VS25 Seal

VS25 SealThis is a bolt on (can be welded on) vertical wear shroud. It fits over a 1" thick bucket cheek plate and can be used on loader as well as excavator buckets. To bolt on torch or drill the side of your bucket to match the bolt pattern. Requires 2, 1"x3 1 2" plow bolts and cone nuts sold separately.

This is a 35pn pin for use with 35s series bucket teeth

Also known as 198-1092

1/2x21/4cap hex cap bolts

Good to weld under the front edge of your bucket to give it a wear surface or to replace the front lip of your bucket

Any final tooling needed you can do such as drilling a hole for a pin keeper or trimming the length

Dust seal for 90mm Bucket Pin/Boss that measures 90mm x 105mm x 4mm also known as 07145-00090

You will also need a 35-40lk lock

Its OD is 120mm and length is 80mm

It is 3 mm thick with an OD of 120 mm

It is 5 mm thick with an OD of 100 mm

This is a genuine ESCO Ultralok replacement lock for all u35 series teeth

This is a Hensley style T156 single pointed bucket tooth