Power Sense Module

Power Sense ModuleThe Power Sense Module (PSM) provides analog current and voltage sensing to your Pixhawk autopilot mounted on your BlueROV2 or custom marine robotics project. Contents 1 x Power Sense Module with pre installed 5. 5mm bullet connectors and spade connectors 1 x 200mm DF13 to JST GH cable 1 x 200mm JST GH to JST GH cable

6 x M3x16 screws

Autosync works by exposing the Receiver and Transmitter to GPS or GNSS signals at the start of the mission and optionally at intervals during the mission

Update rate

One 3-pin connector handles the high-voltage power and ground connection while an 8-pin connector handles the signal connections

With a 300m depth rating and no need to calibrate crystal oscillators or manually sync the distance between units (select auto sync) at mission start-up

Fully integrated Locator device with its own depth sensor and tether

The BLUART has JST-GH connector ports and through-hole options for either serial UART or RS485 connections

1 x Tool Kit and Box

no payload) 3 m/s 6 kts Maximum Static Thrust 8

5mm Max Scan Angle 360° continuous or defined Sector Scan Scan Angle Resolution 0

1 x Aluminium End Cap with 12 x M14

auto sense