CNC Shop - 21369 5-6mm ER 25 Collet Shank:5-6mm

CNC Shop - 21369 5-6mm ER 25 Collet Shank:5-6mmA wide selection of metric and imperial ER type standard collets. These are suitable for use with several spindles including Perske, Elte, Colombo and HSD. Shank: 5 6mm Type: ER 25 It is essential to use the correct size collet for the tool shank diameter. First make sure you are looking at the right type of collet to fit the spindle on your machine and then select the required size from either the metric or imperial range. Use the table below to

1-21007-013 Acculine

006" Ruby WaterJet Orifice

If you are unsure

Type: Arbor

The lubricant also helps minimize melted aluminum clogging the tooling

This 30 Amp disconnect includes the box as shown in the photo along with the rod (not shown) and handle (not shown)

Overall Length: 50mm

Online training sessions can be purchased in 1-hour increments

Using TeamViewer

Overall Length: 76mm

composite plastic and solid surface

Even a very small chip in the cutting edge will cause unwanted marks on the workpiece and lead to faster tool wear