JL Audio M-LCA-C-W Clamps

JL Audio M-LCA-C-W ClampsMachined aluminum rear covers with LED down light for 7. 7 inch ETXv3 and 6. 5 inch VeX enclosed speakers Take your ETXv3 and VeX speaker systems to the next level with these light caps. Purpose built for 7. 7 inch ETXv3 and VeX enclosures, each cap features machined aluminum construction and a built in, down firing LED strip to illuminate the area below with brilliant white light. Installation requires just a single hole to be drilled. For

92 Enclosure Notes

Continuous Power Handling (RMS) 600 W Recommended Amplifier Power (RMS) 200 - 600 W Nominal Impedance (Znom) Dual 4 ohms

86 in / 98 mm

Specification Details CTA-2006 Compliant Yes Number of Channels 4 Total Power (Sum of Rated Power) 400 Watts RMS Rated Power (RMS Continuous Power) 60 Watts x 4 @ 4-Ohm100 Watts x 4 @ 2-Ohm200 Watts x 2 @ 4-Ohm Bridged2-Ohm x 2 Bridged Stable Dynamic Power (PVC/PowerCube®) 84 Watts x 4 @ 4-Ohm 0° Res139 Watts x 4 @ 2-Ohm 0° Res272 Watts x 2 @ 4-Ohm Bridged Bridgeable Yes Frequency Response 20Hz to 20kHz +/- 1dB Input Sensitivity 150 mV to 4 V Circuit Topology Class Class A/B Efficiency (average) 69% @ 4-Ohm68% @ 2-Ohm Total Harmonic Distortion (THD+Noise) 4-Ohm: <1

Breakaway mounting tabs on the woofer frame allow the C2-400x to be installed in four-hole or two-hole configurations

Mounting requires a 1

375 in / 35 mm Internal Slot Port Height (SH) 11

(Analog Inputs) 80 dB (A-weighted

the on-board "Boost" control of the amplifier is defeated and the RBC-1 becomes the active controller

With the Evolution® C3 Convertible Component Systems

Crimpable Power Rings for 1/0 AWG Wire - 4 Pack

Hidden Marine Source Unit